MyAlbum

The first cut is the deepest. No way back now. I know that Unobtainium GB Sells 3D printed Wheels for the Alfa Romeo, but I like to give it a try myself.
The slots are made with a 0,7mm Dental burr 

Made a simple jig for keeping the axle in the center. Spokes and nipples glued with thin super glue. 

First layer (20 spokes + 20 nipples) ready. Two more layers to go with. Total will consist of 60 spokes and 60 nipples and two more for the air valves. I'm a little bit more confident this will work 😉 

Second layer, and again 20 spokes and 20 nipples.

 

The 3th and last layer spokes and nipples + air valve at the right place. All together instead of 3 pieces for a wheel it now has 125 parts. It took me about 5 hours to compleet, but time well spend in my opinion.
The remaining 3 wheels (and car) have to wait till I finished a trio of1:35 Rolls Royce Armoured cars 

The standing figure is Tazio Nuvolari, a well known coureur for (amongst others) Alfa Romeo during the 30's. The sitting figure is a display of Enzo Ferrari which I hope to place in the Alfa.