BMD-1
1
November 14, 2014The first challenge is cleaning the flash from the water intake grills under the hull.2
November 14, 2014The sprockets come in three parts, outer, middle, and inner. It is very difficult to get the outer ring (right) off the massive sprue without it breaking into tiny pieces.3
November 14, 2014The instructions don't tell you that the inner and outer rings can be lined-up to make the lightening holes. A lot of trial and error is needed to get the holes to line up!4
November 25, 2014Added weld beads at proper locations.5
November 25, 2014The plastic in this kit is very soft, scratches (and sands) easily and reacts with thinner, especially lacquer thinner which melts and distorts the surface.6
November 25, 2014Ready to paint!7
December 6, 2014Finally done! The individual tracks (with seperate, individual teeth) were a pain!
Коментарі
7 September 2024, 17:05 -
Album info
Panda Hobby 1:35