hexagonal bolt heads various sizes
Alliance Model Works | No LW35025
Факти
- Марка:
- Alliance Model Works
- Наименование:
- hexagonal bolt heads various sizes
- Номер:
- LW35025
- Мащаб:
- No
- Тип:
- Набор за детайлиране
- Тема:
- Bolts and Nuts » Битове и парчета (Аксесоари)
Пазар
No partner shops available
Преглед на съдържанието
Външни прегледи
Не знаем за съществуващи прегледи на съдържанието hexagonal bolt heads various sizes (#LW35025) от Alliance Model Works.
Коментари
Treehugger
A fun thing about this particular product, is that these photo etch bolt heads do not require any detachment, as the bits of photo etch are stuck to an adhesive plate. So one can just grab a bolt head with a small tweezer and apply it immediately . 🙂 The bits of photo etch has to be glued on though, they do not contain any adhesive from what I can tell.
I should point out that the thickness of this photo etch is limited to, well, I am not sure, looks like fairly standard thickness to the photo etch plate, which may or not be adequate. I wish the photo etch thickness was a little thicker. I guess one could stack two bits on top of each other, but that seems like it might be extremely difficult to achieve.
Also included, some kind of Y shaped thingies, and what looks like the tip of the bolt shaft itself, presumably to be glued on top of the bits of flat bolt head. These small round tips are limited in number, compared to the flat bolt heads.
A fun thing about this particular product, is that these photo etch bolt heads do not require any detachment, as the bits of photo etch are stuck to an adhesive plate. So one can just grab a bolt head with a small tweezer and apply it immediately . 🙂 The bits of photo etch has to be glued on though, they do not contain any adhesive from what I can tell.
I should point out that the thickness of this photo etch is limited to, well, I am not sure, looks like fairly standard thickness to the photo etch plate, which may or not be adequate. I wish the photo etch thickness was a little thicker. I guess one could stack two bits on top of each other, but that seems like it might be extremely difficult to achieve.
Also included, some kind of Y shaped thingies, and what looks like the tip of the bolt shaft itself, presumably to be glued on top of the bits of flat bolt head. These small round tips are limited in number, compared to the flat bolt heads.
28 December 2018, 16:10
Проекти
82 снимки
Trumpeter's Challenger 2 MBT, scale (00345)1:35
Testing outdoor photography. Brr, too cold. :| I have learned that my camera adds increasing blurring towards the edges,...